Consulting

Technical consulting: the most cost-effective solution for your production

The most expensive machine is not always the best. Before you spend your budget, we will check which solution delivers the required result at the lowest cost – both investment and operating.

Machine purchase decisions are often based on a single offer or a well-known brand’s catalogue. Yet the same production result can often be achieved in several ways, and the cost difference can be very large. Sometimes upgrading an existing machine, changing the workstation layout or a used machine with a good history is enough.

We are independent of manufacturers, so we can compare options honestly. We look not only at the purchase price, but also at the cost of installation, regulatory adaptation, service, parts and energy over the entire service life.

Scope of consulting

How we help

  • Audit of the process and machinery: output, downtime, bottlenecks.
  • Comparison of options: new machine, used machine, upgrade of an existing one or a change in work organisation.
  • Cost analysis: investment, payback period, service and parts costs.
  • Supplier selection and verification of offers.
  • Support with technical specifications and requests for quotation.
  • Assessment of the planned investment’s compliance with EU regulations at the purchase stage.
How we work

How we work

We start with a short call and a visit to your plant. After the analysis, you receive a report with 2–3 options, their costs and a recommendation. If you decide to go ahead, we will carry out the project from start to finish.

When

When to call us in

  • You are planning a machine investment and want to compare options before buying.
  • You have offers from several suppliers and don’t know which one is really the best value.
  • Production is not reaching the target output and the cause is not obvious.
  • You want to reduce the unit cost of your product without major spending.
  • You are launching a new product or a new plant and need a plan.
Cooperation

Ways to work with us

  • One-off consultation – a call or visit with a short summary of recommendations.
  • Audit with a report – a full process analysis and solution options with costs.
  • Project support – we accompany the investment from specification to acceptance.
FAQ

Consulting FAQ

No. The report is yours and you can implement it with any contractor.

Yes. We assess the machine’s condition, its compliance with regulations and the cost of bringing it back to full working order.

Book a consultation – we will discuss your process and possible solution options.

Contact usContact us